angle of torque
英 [ˈæŋɡl ɒv tɔːk]
美 [ˈæŋɡl əv tɔːrk]
网络 扭转角
双语例句
- The amplitude of stator flux and torque angle in permanent magnet synchronous motor ( PMSM) are controllable, the implementation method of direct torque control in PMSM is not unique.
永磁同步电机转矩中定子磁链幅值和转矩角均为可控变量，直接转矩控制的实现方法不唯一。 - Through photoelectricity method, the torque angle of the revolving shaft is precisely measured to get dynamic torque and speed.
通过光电方法精密测量旋转轴的扭转角获得动态扭矩和转速； - A mathematical model was created to analyze the torsional angle of the mass following the input acceleration, the electrostatic force caused by the torque generator, the bending of the torsion har and the capacitance error.
并对其进行了数学建模，分析了加速度输入时质量片扭转角的大小、力矩器产生的静电引力及支承梁的弯曲挠度和电容误差，给出了检测得到的加速度计的性能。 - Influences on the speed and direction of the rotation by the phase angle of the supply voltage, initial angle of rotor position, PM line flux and the load torque are discussed.
同时讨论了电源合闸角、转子初始相角、磁链和负载转矩对电机转速和旋转方向的影响。 - Like synchronous motor, rotor magnetic pole center line could lagged behind an angle of that of air-gap magnetic field under the function of load torque ( called angular displacement).
步进电动机象同步电动机一样，在负载转矩的作用下，转子磁极中心线将滞后于气隙磁场的中心线一个角度，称为失调角。 - Based on this test bed, the force to separate seedlings was measured and the relationships between rotary angle of gears trunk and the bearing force of chain and the base of transplanting mechanism were obtained by using torque sensor, information collecting set and information processing software.
在该试验台上，利用扭矩传感器、信号采集仪和相应信号处理软件，测得一个插秧循环中取秧力和链条、分插机构支座受力与行星架转角的关系。 - It is, therefore, considered that the proper reduction of cam angle is useful to improve the driving performances of the torque sensing variable V-belt drive.
认为适当减小凸轮升角有利于改善扭矩感应带式无级变速器的传动性能。 - Our calculation results show that the idle angle of the common roller overrunning clutch is less than 2 °, when the clutch transmits the nominal torque.
对平面内星轮滚柱超越离合器，计算结果显示：空转角一般不超过2°； - The influence of tooth harmonic positioning torque of DC motor on rate smoothness of test table is analysed in this paper, and a self-learning control scheme based on angle displacement period is presented for compensating the effect of torque fluctuation.
本文分析了直流电机的齿谐波定位力矩对转台速率平稳性的影响，提出一种基于角位移周期的学习控制方案，以补偿力矩波动对速率系统性能的影响。 - Amplitude and instantaneous position angle of the stator flux linkage can be controlled by a equivalent symmetrical voltage vector of arbitrary direction and controllable magnitude, thereby, expectational torque will be achieved.
该调制方法获得方向任意且大小可控的等效电压矢量，以此控制定子磁链的幅值和旋转速度，从而达到对输出电磁转矩的有效控制，并获得恒定的器件开关频率。 - In this paper, an extended Phillips-Heffron model of a power system with TCSC is established. The analytical solution that TCSC damping characteristic appears negative under open-loop control with constant firing angle is obtained by analyzing the dedication of TCSC to synchronous and damping torque in power system.
文中建立了装有TCSC的电力系统的扩展Phillips-Heffron模型，通过分析TCSC对系统同步和阻尼转矩的贡献，给出了在开环定触发角控制下TCSC表现为负阻尼特性的解析解。 - It includes: discussion about the reasonable selection of construction parameters of the bearing, deduction of the relationship between bearing clearance and contact angle, and emphasis on the significance of assembling accuracy and torque measurement in the assurance of operational performance of the bearings.
其中包括轴承各结构参数的合理选择，轴承游隙与接触角之间的关系，分析了装配精度和转矩监测。 - Angle of peak torque ( APT) indicates angle of extensors are lower than flexors. There aren't significant differences between right and left in APT;
屈伸肌群达峰力矩的角度（APT）表现为伸肌角度明显低于屈肌角度，随速度增加左右两侧膝关节达峰力矩的角度无显著差异； - It is applied to the optimization of inlet and outlet angle of blade cascade of torque converter ( YB380). The result indicates that the maximum efficiency of calculated work condition is improved from 0.866 to 0.9 and that this method is feasible.
将该方法应用于YB380型液力变矩器叶栅进出口角的优化，结果表明，通过优化使计算工况最高效率由0.866提高到0.9，从而证明本方法的可行性。 - Angle. Computer Measuring System of Engine Spark Advance for Torque
发动机点火提前角自动测试系统 - Objective To evaluate the factors effecting the concentric isokinetic angle of peak torque ( AOPT).
目的了解影响峰力矩角度（AOPT）的因素，确定向心性屈、伸膝峰力矩角度的正常值范围。 - By adding the on-off mode of two phases, 14 voltage space vectors can be added and the step angle of voltage vectors can be effectively reduced with the vector subdivision method based on direct torque control ( DTC), and improve torque fluctuation.
采用直接转矩控制硬件矢量细分法，通过增加两相导通产生14个空间电压矢量，能减少电压矢量步进角，改善转矩脉动。 - Based on fuzzy-logic turn-off angle optimization, the simulation of SRD is established under voltage chopper control. The real-time optimization to turn-off angle of SRM is carried out by using fuzzy logic controller to reduce torque ripple.
SRM采用电压斩波控制方式，建立基于模糊逻辑优化关断角的SRD仿真，利用模糊逻辑控制器对SRM的关断角进行实时优化，从而达到抑制转矩脉动的目的。 - The main parameters to reflect dynamic characteristics of mechanical transmission such as rotor angle, vibration angle and angular acceleration can be fetched by analyzing of torque.
通过对扭矩的分析，可提取有效反映机械传动系统动态特性的转角、振角、角加速度等主要特征参量。 - The enter angle features of the steering wheel, the actuator response, the feedback torque characteristics of electromagnetic force on the steering and vehicle characteristics are simulated.
对转向盘输入转角特性、转向执行机构的响应、电磁施力器反馈力矩特性以及整车的转向特性进行了仿真分析。 - The turn-on angle and turn-off angle of the main switch in the voltage PWM control are optimized by the maximal start torque and minimal start torque ripple.
对不同转速下，电压PWM控制的主开关器件的开通角和关断角进行了基于起动转矩最大和起动转矩脉动最小两种情况下的角度优化，得出了最优角度。 - When the camber and lateral angle are of same sign, lateral force is promoted, and cornering torque is suppressed.
当侧倾角与侧偏角同号时，侧向力被促进，回正力矩被抑制。 - Its basic principle is changing the angle between stator flux and rotor flux by adjusting the rotating speed of stator flux while the amplitude of stator flux is constant, then the electromagnetic torque and rotor speed are controlled.
其基本思想是在保持磁链幅值不变的情况下，通过调整定子磁链的旋转速度来改变定子磁链与转子磁链间的夹角，以达到控制电磁转矩，进而控制电机转速的目的。 - The results show that: the torque transmission angle is very effective to the condition of multi-force on the output component; there are no dead points of the power transmission equipment, though the torque transmission angle is small. ( 3) Kineto-static analysis.
分析结果表明：力矩传动角可以有效地用于旋转输出构件多点受力时的情况；功率传输机构不存在死点，但力矩传动角较小。（3）动态静力学分析。 - Based on the real-time detection to the current, position angle and magnetic chain of the motor, the micro controller estimates the instantaneous torque of the motor, thus to realize the direct torque control to the SR motor.
通过对电机的电流、位置角度和磁链的实时检测，经微控制器估算出电机瞬时转矩，实现对开关磁阻电机的直接转矩控制。